[DX11] Help regarding Nvidia Profile Inspector (NPI)

[JHTrucker]

@BenganJ - Thanks for updates to post 1...

Can i ask for a further relocate?
I'm just thinking the AA pairs look a bit lost at the end of the post and could easily be missed.
Perhaps they would look better just after Wombat's video and just before your settings.

Available AA pairs to try - Low to High

'2x [2x Multisampling]'
'2x Sparse Grid Supersampling'

'4xS [Combined 1x2 SS + 2x Multisampling (D3D Only)]'
'2x Sparse Grid Supersampling'

'4x [4x Multisampling]'
'4x Sparse Grid Supersampling'

'8xQ [8x Multisampling]'
'8x Sparse Grid Supersampling'

'32xS (Combined 2x2SS + 8xMS)'
'8x Sparse Grid Supersampling'

"Below are a more complete set of settings for you to test, in some cases with alternatives!"
etc

I'm happy if you don't agree.
Thanks.

[Road Runner]

@BenganJ

Been for a drive, visited dealer exited all no problem with 4.3 - strange :?

[BenganJ]

@JHTrucker

Oh, I'm open for any suggestions, so I'll check it out and we'll see! :D

[BenganJ]

@Road Runner

We probably have some differing setting somewhere. E.g. have you any shader
activated? Which multimon_config.sii do you have? Which AO pattern?

[BenganJ]

@JHTrucker & @Road Runner

I have these settings in my multimon_config.sii! Can it be that those numbers are too tight,
causing the split Menu screen?

Code: Select all

 normalized_ui_x: 0.0005
 normalized_ui_width: 0.999

[JHTrucker]

Try that:
normalized_ui_x: 0.005
normalized_ui_width: 0.99
or
normalized_ui_x: 0.1
normalized_ui_width: 0.8

to really check it... but i'm guessing it's reshade issue.

[BenganJ]

@JHTrucker

Yes, I think so too and it's pretty easy to test, so I'll do that! :D

[Tapir]

@Tapir

But did you test to go back to v4.2.1? I had no problems with that!

I found no download for 4.21

[BenganJ]

@Tapir

No problem, but can you give me your lines from multimon_config.sii, these two?

Code: Select all

 normalized_ui_x: 0.0005
 normalized_ui_width: 0.999

@JHTrucker

Actually, I got no problems after changing the two lines above to,

Code: Select all

 normalized_ui_x: 0.005
 normalized_ui_width: 0.99

which, if I remember correctly were your first values! No, that was 0.95! DAMN!

[Tapir]

Code: Select all

 normalized_ui_x: 0.001
 normalized_ui_width: 0.999