[DX11] Help regarding Nvidia Profile Inspector (NPI)

[BenganJ]

@Crossfire

Anytime mate, just ask! Enjoy the game!

[Crossfire]

@benganJ Hello again comrade Bengan. I didnt understand this adjustment below . should I make this adjustment? if yes where can ı do this?

NCP Image sharpening:
----------------------------
Image sharpening ----------- 'On' //This setting is an alternative to the NPI way, should be done ONLY for ETS2 and ATS under TAB Program settings. Same values.

[BenganJ]

@Crossfire

If you look at the very beginning of first post, there's a note about which Nvidia driver version you use.
If you use a recent one, that parameter has been removed, so skip that in that case. It was in an earlier
driver version possible to set both in Nvidia Profile Inspector and Nvidia Control Panel.

[Crossfire]

@ bengan J . OMG. I was dowloaded the latest version of nvidia profile inspector that is 3.5.0.0 !!! and in there there are some different parameters. should I erase that one and install 2.3.12 version?

[BenganJ]

@Crossfire

YES!

[JHTrucker]

Crossfire said "Comrade Bengan. Thanks for your suggestion regarding Faal environemnt. It is great. And I tried both 4x supersamling and 32x supersampling. my fps is 100 in avarage by 32x supersampling. But there are difference between 4xs and 32s in graphics comrade."

A bit of confusion regarding the above.
You are comparing 4xs & 32xs which is the same as comparing 2x & 4x. There's a massive visual difference.

But, anything above 4x is just 4x and 4xs is actually below 4x.
From first post:
'4xS [Combined 1x2 SS + 2x Multisampling (D3D Only)]'
'2x Sparse Grid Supersampling'

'4x [4x Multisampling]'
'4x Sparse Grid Supersampling'

[Crossfire]

@ jhtrucker In this case what should I use? As ı said I am not experienced in this situations like you. you see my hardware properties. WHAT DO U SUGGEST? COMRADE BENGAN SAID IT IS NOT NECESSARY to use 32xs

[BenganJ]

@Crossfire

I suggested you to use the 4x level not the 4xs level and I think JHTrucker will say the same,
but you will hear it from him later!

[Crossfire]

ok thanks comrades :) I am an old man please be patient to me :)

[JHTrucker]

@Crossfire - We're all old men!

Simply that 4xMSAA with 4xSGSS is the highest setting visually that works for our AA.
Anything above it, 8x, 8xs, 16xs & 32xs are all just 4x.
That video was made prior to the discovery that 32xs is just 4x.
You can check this for yourself:
Set to 32xs and check FPS (no vsync) in game.
Set to 4x and check FPS (no vsync) in game.
Both should be the same FPS value.
If 32xs shows a much lower FPS then perhaps your card is somehow able to produce that AA level?

But 4x is more than good enough. Plus if you're using a single screen, try adding the DSR option to it to increase the resolution (read note 4 on the first post)... BenganJ does that.