Change ATS Prefabs to Left Side Traffic

[b738pilot]

Hello,

I need help please. I have two prefabs from ATS:

us_cross_1-1_country_t_dock_short_tmpl.pmd
us_fork_2-2_country_1-1_country_tmpl

that I need to get to left side driving traffic in ATS. I tried importing some UK roads from ETS2 but they do not mesh up and AI does weird stuff. I am aware that Blender is involved in this and I have very little Blender knowledge, so I was hoping someone here may have some time to help me out and convert these two prefabs over to left hand traffic for my map. Would really appreciate it! Thanks a lot!

[Stefan E.]

Um, I am not an expert in this field, but I know that on ETS2 there is an option in Properties with which you can select to drive on the left.
It is also valid in ATS, can you check?

[Arayas]

That option is there but is disabled for more than a year

[b738pilot]

I appreciate the suggestion, but yeah as Arayas said, that left side traffic tick button doesn't do anything anymore on the prefabs.

From what I researched, it has to be imported into Blender, the lines reversed and entry points, then exported back to SCS. I don't know how to do any of that.

[b738pilot]

Would trajectories work?

[b738pilot]

I was playing around with trajectories. It works perfectly on the T-cross intersections. However, the merge lanes when going from 2 to 1, the AI tries to cut each other off and does not give way, causing accidents nearly every time making a big traffic jam...basically, driving like a bunch of New Yorkers or New Jerseyians :)

so the next issue is how to fix that....

[Arayas]

trajectory will not take priority in consideration, atlest i didnt get them to respect traffic rules.

[b738pilot]

I was reading that too... hmm.. so in the case of a merge, it's probably best to just reduce the traffic density and see the occasional accident.