[DX11] Help regarding Nvidia Profile Inspector (NPI)

[clear F1]

If r_sun_shadow_texture_size "4096", I don't think there will be any problem, so I give up.

https://gpu.userbenchmark.com/Compare/N ... 4048vs3609

[BenganJ]

@clear F1

Can you do the test I proposed one post up? I want to see if it can be one of your mods that is causing this!

[clear F1]

I can still stand it.
3:00 am

[BenganJ]

@clear F1

Sorry, go to sleep now, we can do that tomorrow! Sleep tight!

[clear F1]

Nothing happens. Mods?
Sleep.
Once again, just like before, install and test each mod one by one.

[BenganJ]

Yes my friend, sleep tight now! see you tomorrow!

[clear F1]

@ BenganJ

I could only get the same result as last time.
The test is the following conditions.
Nvidia driver 442.74, With DSR x1.78, Vsync "2", NPI setting (2.3.0.10), r_sun_shadow_texture_size "8192"

1. SAT BG on top of vanilla base combo, and mod for geme data.sii on top. => Nothing happened
2. Installed under the SAT BG from the sound system mod that is usually put in the upper level. => Nothing happened
3. Install Project NG2.0. => Nothing happened
4. Here, take a break and finish the game.
--- Browse YT and RoEx forums while drinking coffee. --- :D
5. Start ETS2 after about 20 minutes and get 20 fps at the same place as yesterday.
6. Oh, NG2.0? Go back to your profile and remove NG 2.0. But 20fps in the same place.
7. Furthermore, remove mods other than the map and SAT BG. It became the same state as the first "1" this time, but 20 fps at the same place.
8. Change r_sun_shadow_texture_size "8192" to 4096 and start ETS2, no problem at the same place.

Do you want to use it as it is at “4096”, or be prepared and start by reinstalling Windows? :( :( :(


Edit:
I continued the more severe test. :(
We tested all mods except Map and identified the mod causing the raindrop problem.
Regarding opening and closing of windows, it works if you remove mods other than Map. When I put something in the mod, it stopped working and I couldn't locate the mod.
"8192" always happens regardless of mod, and if "4096" is used, it will be cured.

[BenganJ]

@clear F1

I must ask a couple of questions here.
1. So, you had a whole combo map plus the SAT BG to start with? If so, please do as I asked you to do earlier, create a new profile with ONLY RoEx2.6 in it, NOTHING more. Test!
2. Have you lately done this? Rename your config.cfg so that you can restore it if needed, then start the game, let it create a new config.cfg, configure it as usual. Test!
With the hardware you have you definitely should be able to get a better result than me and I have no problem driving around in Kropyvnytskyi!

[clear F1]

1 was confirmed yesterday. There was no problem.
2 will be tested later.

I can't understand it further, I just modified the track colors, etc., but when I started the game, the windows were working for some reason.

[clear F1]

Only one is getting better. DSRx1.78 can be used with "4096". I couldn't do that before.