[DX11] Help regarding Nvidia Profile Inspector (NPI)

[BenganJ]

@idamasce

Welcome here! The Silk_Smoothness is at the same location in NPI as it always has been:
Here's a picture of NPI 2.3.0.12 with marks for you:

NPI_SILK.JPG

[idamasce]

the version I have here doesn't have it! weird ne, I have print here to prove what I say so I don't know how to put it here on the forum!

[BenganJ]

@idamasce

Let's see if we can sort this out! Which version of the Nvidia driver are you using?
And which graphics card do you have?

[idamasce]

a versao mais atual do driver da Nvidia 445.87 minha placa grafica e uma GTX 1080

English: the most current version of the Nvidia 445.87 driver my graphics card is a GTX 1080

Please, use English in this forum! //BenganJ (Moderator)

[BenganJ]

@idamasce

Interesting, but can you do me a favor before we delve into this any further?
Install the Nvidia Hotfix version 445.98 and see if the same applies there!

[idamasce]

OK! I will look for this driver mentioned by you, install it and let you know ok!

[BenganJ]

@idamasce

Yep, see you later!

[idamasce]

Geforce Game Ready Driver WHQL 445.87
Geforce Game Ready Driver WHQL 445.98, I tested this 02 drivers and it is not possible to enable --- SILK Smoothness '0x00000004' in Nvidia Inspector 2.3.0.12,
a doubt I have every time I install a new driver I have to configure Multimon_Config and Global Config.cfg again

[BenganJ]

@idamasce

Why would you have to reconfigure multimon_config.sii and config.cfg after a Nvidia driver installation?
The only thing you have to do is load your exported NPI config and hit Apply changes! And what do you
mean by NOT POSSIBLE to config SILK Smoothness in 2.3.0.12?

[BenganJ]

@clear F!

I can tell you that I have problems on that route between YKSRSK and SRMap too.
Can you test to change to Arayas connection mod and see if that is different?
Now I am off to bed, but we will meet tomorrow again! See you later!